[Full-Version] 2024 New TrainingQuiz 300-815 PDF Recently Updated Questions [Q94-Q114]

4/5 - (1 vote)

[Full-Version] 2024 New TrainingQuiz 300-815 PDF Recently Updated Questions

300-815 Exam with Guarantee Updated 176 Questions

NEW QUESTION 94
The administrator of ABC company is troubleshooting a one-way audio issue for a call that uses
H.323 protocol (slow-start mode). The administrator requests that you provide the IP and port information of the Real-Time Transport Protocol traffic that had the one-way audio call.
You gather the H.225 and H.245 messages for one of the one-way audio calls.
Where can you find the RTP IP and port information for both sides? (Note: This call flow has not invoked any media resources like MTP or transcoders).

H.245 Terminal Capability Set

H.245 Open Logical Channel

H.225 Connect

H.245 Open Logical Channel Ack

H245 Open Logical Channel contains only RTCP port, H245 Open Logical Channel ACk will have both RTP and RTP Port.
https://community.cisco.com/t5/collaboration-voice-and-video/h323-call-flow/ta-p/3160014

NEW QUESTION 95
The company Cisco UCM cluster has two different gateways for off-net calls. The current configuration uses 9 as a prefix to get to the main gateway. The secondary gateway is for any calls that start with 9713, but this is not yet configured. The admin does not want to add more route patterns other than the current 9 prefix for the gateway to the Cisco UCM. How must the Cisco UCM be configured to meet the requirements?

Configure a Route Group and a Route List to send calls with prefix 9713 to the secondary gateway.

Configure two partitions and two CSSs, then add a translation pattern with the secondary CSS to send all calls with 9713 to the secondary gateway.

Configure two CSSs, then add a translation pattern with the secondary CSS to send calls with
9713 to the secondary gateway.

Create a Standard Route Group to dynamically route calls with prefix 9713 to the secondary gateway.

NEW QUESTION 96
What is first preference condition matched in a SIP-enabled incoming dial peer?

incoming uri

target carrier-id

answer-address

incoming called-number

https://www.cisco.com/c/en/us/support/docs/voice/ip-telephony-voice-over-ip-voip/211306-In- Depth–of-Cisco-IOS-and-IO.html#anc8

NEW QUESTION 97
Refer to the exhibit.

An administrator is troubleshooting why users are not hearing audio when dialing long distance numbers across their Cisco Unified Border Element. The customer’s carrier has a requirement that dialing long distance requires an access code to be entered. Looking at the exhibit, what two actions can be taken to correct signaling? (Choose two.)

Enable PRACK.

Enable Early Offer on the Cisco Unified Border Element.

Enable the supplementary-service media-renegotiate command.

Enable Media Flow Around

Enable Mid-Call Signaling Consumption.

NEW QUESTION 98
Refer to the exhibit.

A user reports that when they call a specific phone number, no one answers the call, but when they call from a mobile phone, the call is answered. The engineer troubleshooting the issue is expecting the far-end gateway to cut through audio on the 183 Session Progress SIP message. Which SIP Profile configuration element is necessary for the Cisco Unified Communications Manager to send acknowledgement of provisional responses?

Allow Passthrough of Configured Line Device Caller Information must be enabled.

Accept Audio Codec Preferences in Received Offer must be set to On.

On the SIP Profile, the configuration parameter SIP Rel1XX Options must be set to Send PRACK for all 1xx Messages.

Early Offer for G Clear Calls must be enabled.

NEW QUESTION 99
Which built-in bridge configuration option can be set on the individual IP phones to ensure that the cluster-wide service parameter is used?

automatic

default

off

NEW QUESTION 100
Refer to the exhibit. Users report that outbound PSTN calls from phones registered to Cisco Unified Communications Manager are not completing. The local service provider in North America has a requirement to receive calls in 10-digit format. The Cisco Unified CM sends the calls to the Cisco Unified Border Element router in a globalized E.164 format. There is an outbound dial peer on Cisco Unified Border Element configured to send the calls to the provider.
The dial peer has a voice translation profile applied in the correct direction but an incorrect voice translation rule applied, which is shown in the exhibit. Which rule modified DNIS in the format that the provider is expecting?

rule 1 /^/+([^1].*)/ /0111/

rule 1/^+1([2-9]..[2-9]……$)/ /1/

rule 1 /^([2-9]..[2-9]……$)/ /1/

rule 1 /^+1([2-9]..[2-9]……$)/ //

NEW QUESTION 101
An engineer must configure call queuing under a Hunt Pilot. After the engineer receives the audio file that will be played to callers during queuing, which two steps should be taken to complete the configuration? (Choose two.)

Upload the audio file in “TFTP File Management” via OS Administration GUI

Assign the uploaded audio file to the hunting Line Group member’s “Network Hold MOH Audio Source”.

Upload the audio file in “MOH Audio File Management” via CM Administration GUI

Assign the uploaded audio file to the hunting Line Group member’s “User Hold MOH Audio Source

Assign the uploaded audio file to “Network Hold MOH Source & Announcements” under Hunt Pilot’s Queuing section.

NEW QUESTION 102
Single number reach call phone that not answered are leaving voicemails on the cell phone rather the corporate mailbox. Which two options will resolve this issue? (Choose two.)

Check the Enable Extend and Connect checkbox

Check the Enable Unified Mobility features checkbox

Decrease the T302 timer

Decrease the T301 timer Decrease the Answer Too Late timer

Decrease the T301 timer.

Decrease the Answer Too Late timer.

NEW QUESTION 103
Refer to the exhibit.

Users report that when they dial the emergency number 9911 from any internal phone, it takes a long time to connect with the emergency operator. Which action resolves this issue?

Adjust the service parameter T302 timet to the desired value.

Adjust the service parameter T204 timer to the desired value.

Check the Urgent Priority check box under 9.911 pattern.

Point the emergency pattern directly to the PSTN gateway.

NEW QUESTION 104
Which two types of authentication are supported for the configuration of Intercluster Lookup Service? (Choose two.)

TokenID

username and secret key

TLS certificates

passwords

FQDN of the servers defined in DNS

Section: Cisco Unified CM Call Control Features
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/11_5_1/ sysConfig/11_5_1_SU1/cucm_b_system-configuration-guide-1151su1/cucm_b_system-configuration-guide-
1151su1_chapter_011001.pdf

NEW QUESTION 105
A company is using Cisco Jabber on-premises to make B2B calls on video. The calls are using Cisco Expressway-C and Expressway-E and have been configured in Cisco UCM to be able to call any URI on the internet. The Jabber client also has voice enabled and must be able to call local, regional, and international numbers. Where must Cisco UCM be configured to meet this requirement for URI dialing?

Enter “!#” in the route pattern section tied to a route group and list.

Enter “*” in the SIP route pattern.

Enter “!#” in the SIP route pattern.

Enter “.*” in the route pattern section tied to a route group and list.

NEW QUESTION 106
An engineer Is configuring a Cisco Unified Border Element. The SIP ITSP requires a DNIS of 10-digits and DTMF tones sent in the RTP stream on the outbound leg of a call. Which code completes this configuration?

NEW QUESTION 107
Which description of RTP timestamps or sequence numbers is true?

The sequence number is used to detect losses.

Timestamps increase by the time “carrying” by a packet.

Sequence numbers increase by four for each RTP packet transmitted.

The timestamp is used to place the incoming audio and video packets in the correct timing order (playout delay compensation).

Section: Signaling and Media Protocols
Explanation/Reference: https://www.cs.columbia.edu/~hgs/rtp/faq.html

NEW QUESTION 108
Refer to the exhibit. Within the North American Numbering Plan, gateways located in Ottawa, Canada and marked as “YOW” are assigned to the Calling Party Transformation CSS NANP_CgPTP, which contains partition NANP_calling_xforms. What is the calling-party number and the numbering type if the calling user +1613-555-1234 dials the number?

calling number 613-555-1234 and numbering type “subscriber”

calling number 011-1-613-555-1234 and numbering type “subscriber”

calling number 011613-555-1234 and numbering type “international”

calling number 613-555-1234 and numbering type “national”

NEW QUESTION 109
Configure Call Queuing in Cisco Unified Communications Manager. Where do you set the maximum number of callers in the queue?

in the telephony service configuration

in the queuing configuration

in Cisco Unified CM Enterprise Parameters

in Cisco Unified CM Service Parameters

https://www.cisco.com/c/en/us/support/docs/unified-communications/unified-communications- manager-callmanager/200453-Configure-CUCM-Native- Call-Queuing-Featu.html

NEW QUESTION 110
An administrator is configuring Meet-me conferencing in a Cisco UCM deployment and has created the Meet-me number and ensured that it is in a partition accessible by all devices. Which two additional steps must the administrator perform? (Choose two.)

Ensure that conferencing-initiating devices are using a media resource group list that contains at least one Cisco UCM conference bridge.

Disable Early Media on the SIP profile of all devices that will use Meet-me conferencing.

Enable Meet-me conferencing in enterprise parameters.

Ensure that all devices have G.729 enabled.

Update the softkey template on all phones to ensure that they contain the Meet-me softkey.

NEW QUESTION 111
Which configuration must an administrator perform to display Translation Pattern operations in Cisco Unified Communications Manager SDL traces?

Enable the Detailed Call Analysis option under Enterprise Parameters for Unified CM.

Set up the Digit Analysis Complexity in Service Parameters for Cisco Unified CM to TranslationAndAlternatePatternAnalysis.

Check the Translation Patterns Analysis check box in Micro Traces on the Cisco Unified CM Serviceability page.

By default, the Translation Patterns operations are printed in SDL traces, so no additional configuration is necessary.

https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/hcs/12_5/HCS_Solution/Troubleshooting/ chcs_b_troubleshooting-guide/chcs_m_troubleshooting-voice-application- components.html?dtid=osscdc000283

NEW QUESTION 112

Refer to the exhibit. An engineer configures Cisco Unified Border Element to connect the enterprise VoIP network with a SIP telephony provider. Calls are not working in either direction. What must be configured in the dial peer 1 to fix the issue?

answer-address 555 ……..

codec g729

session-protocol sipv2

incoming called number 555…….

Section: Call Control and Dial Planning

NEW QUESTION 113
What is first preference condition matched in a SIP-enabled incoming dial peer?

incoming uri

target carrier-id

answer-address

incoming called-number

NEW QUESTION 114
Refer to the exhibit. A collaboration engineer is troubleshooting an issue where the PSTN calls of a Cisco UCM IP phone user are not reaching the PSTN gateway. Which action resolves the issue?

Change the calling search space of the user’s line or device.

Change the “Call Classification” to “OnNet” on the route pattern.

Ensure that the user’s phone is assigned to a device pool with the correct local route settings.

Deselect “Block this pattern” on the route pattern.

Loading …

Cisco 300-815 exam is a challenging certification test that requires a lot of dedication, hard work, and hands-on experience. Passing 300-815 exam can help IT professionals to demonstrate their expertise in advanced call control and mobility services, which can boost their career prospects and open up new job opportunities in the field of Cisco collaboration.

The Implementing Cisco Advanced Call Control and Mobility Services exam covers a wide range of topics related to call control and mobility services. 300-815 exam is designed to test the candidate’s knowledge of Cisco Unified Communications Manager (CUCM), Cisco Unity Connection, Cisco Unified IM and Presence, and Cisco Expressway. 300-815 exam also covers topics such as call routing, dial plans, media resources, and call admission control.

Latest 300-815 Pass Guaranteed Exam Dumps Certification Sample Questions: https://www.trainingquiz.com/300-815-practice-quiz.html