2026 H13-624_V5.5 Premium Files Test pdf – Free Dumps Collection [Q41-Q57]

Rate this post

2026 H13-624_V5.5 Premium Files Test pdf – Free Dumps Collection

Get ready to pass the H13-624_V5.5 Exam right now using our HCIP-Storage Exam Package

Huawei H13-624_V5.5 Exam Syllabus Topics:

Section	Objectives
Huawei Intelligent Storage Products and Features	– Resource optimization – Product models – Advanced features – Storage tuning – Huawei-specific technologies – Management interfaces – Data protection – System operations – Huawei storage solutions
Basic Storage Technologies	– RAID levels – Data protocols – Data protection mechanisms – Storage networking – SAN and NAS environments – I/O performance concepts – Storage architecture fundamentals – Storage types comparison
Flash Storage and Scale-Out Storage	– Technical principles – Functions and application scenarios – Typical application scenarios – Software and hardware deployment methods – Performance test analysis and optimization – Software and hardware architectures – Storage system troubleshooting processes and methods – Usage of storage O&M tools
Storage System O&M Management	– Health checks – Troubleshooting and fault handling – Proactive maintenance – Daily operational management of Huawei storage systems – Efficient use of Huawei’s O&M tools – System monitoring

QUESTION 41
Which of the following statements about snapshots is correct

Snapshot is the newly written data

Snapshot refers to a consistent data copy of source data at a certain point in time

Snapshot data can only be read by the host and cannot be changed

Snapshot is a physical copy of the complete source data

QUESTION 42
Fill in Blank
An engineer can use the ______ tool to install software for Huawei storage systems. This tool can collect and evaluate storage compatibility information in one-stop mode and supports batch installation of the UltraPath software, improving the software installation efficiency.

StorageDeploymentToolSDT
Explanation:
The *HCIP-Storage V5.5 Training Material (Module 5: Storage System Maintenance and Troubleshooting)* describes the tools used for Huawei storage system deployment: “The Storage Deployment Tool (SDT) is designed to streamline software installation for Huawei storage systems. SDT collects and evaluates compatibility information in a one-stop manner and supports batch installation of UltraPath, the multipathing software, enhancing installation efficiency.” The SDT automates and simplifies deployment tasks, making it the correct tool for this description.
Reference:
HCIP-Storage V5.5 Training Material, Module 5: Storage System Maintenance and Troubleshooting, Section 5.6: Deployment Tools and Software Installation*, Huawei Technologies Co., Ltd.
—

QUESTION 43
The following description of the characteristics of the DME architecture, which is correct to choose more ()

Can only take over Huawei storage devices

Fully open the system in the north-south direction, and provide RESTful, SNMIP, and ecological plug- ins (such as Ansible, etc.) in the north direction Docking with the upper-level system, southbound SNMP, RESTful, etc. Open interface protocol docking storage

Distributed microservice architecture, high reliability

Supports the management of large-scale storage devices, a single node can manage 16 storage

QUESTION 44
When purchasing storage devices, which of the following criteria will an enterprise use to evaluate the storage devices? (Multiple choice)

Cost

Competitiveness

Accessibility

Occupied space

QUESTION 45
Single choice, the underlying virtualization of the N8000 cluster NAS system is realized through the VxVM component. The virtual objects managed by VxVM are: VM Disk, Disk Group, Subdisk, Pick, which one of the following explanations is correct?

N8000 cluster file system VxM is a non-journal file system that can support files above 2T

File system snapshots use copy-on-write (copy-on-write technology), and share partition or volume storage with other file sets space The snapshot provided by

N8000 is based on the file system level the snapshot provided by the

document N8000 is based on the file system level checkpoint

QUESTION 46
The database architecture can be classified into the storage-compute coupled architecture and storage-compute decoupled architecture. Which of the following are defects of the storage- compute coupled architecture?

The server lacks the disk health management capability.

Services are suspended due to partial congestion, and performance bottlenecks exist.

Only cache data is synchronized between the primary and secondary nodes. Log data is inconsistent.

Performance and reliability cannot be balanced.

In storage-compute coupled architecture, performance bottlenecks and service suspensions can occur due to resource contention, and it is challenging to balance performance with reliability. The other options relate more to data consistency and management features rather than inherent architectural defects.

QUESTION 47
(multiple choice) Which of the following is correct in IDC’s description of the characteristics of big data?

Volume

Variety-Diversity

Value-value density

Velocity-speed

QUESTION 48
To prevent misoperations from affecting services, a storage system controls user operation permissions and scopes based on user levels and roles. Which of the following is not a tenant management user role in the storage system?

Tenant administrator

Tenant protocol administrator

Tenant data protection administrator

Security administrator

QUESTION 49
The storage device generates a fault alarm. Which of the following methods cannot collect storage system faults?
information( )

Check the zone configuration

Check all events

Export system data

Check the warning information

QUESTION 50
When delivering a Huawei OceanStor Pacific scale-out storage project, Huawei engineers introduced the end-to-end load balancing capability supported by the scale-out storage to the customer. Which of the following statements are false about the load balancing capability?
(Choose all that apply.)

The route-based hash policy of the persistence layer is different from that of the service layer.
The route-based hash policy of the persistence layer is implemented based on weights, while that of the service layer is implemented based on STORE DHT.

In load balancing at the semantic layer, a directory is divided into 256 partitions by default and can be adjusted to a maximum of 512 partitions.

Routes at the service layer balance storage space and accelerate fault reconstruction.

Unstructured and structured services at the service layer have different route-based hash policies. However, both unstructured and structured services are mapped based on the same basic routing model.

In the semantic layer, directory partitioning parameters are fixed by the system design and are not adjusted in the manner described. Load balancing at the service layer focuses on request distribution and space balance, while fault reconstruction acceleration is handled by lower layers rather than by service-layer routing.

QUESTION 51
In order to ensure performance and improve disk utilization in Huawei Oceanstor 9000, it is recommended that you The stripe value is set for the piece size. Which one of the following describes the wrong stripe setting?

The relationship between redundancy ratio and read/write performance from high to low is:
N+l>N+2=N+2:1> N+3:1>N+4

Only non-empty directories can modify the redundancy ratio

The relationship between stripe size and read and write performance is: 512KB>256KB>128KB> 16KB

The modified strip size is only effective for the file that was written, and the existing file before modification still keeps the strip size before modification

QUESTION 52
Similar to the alarm analysis method, the replacement method can be used to locate and rectify any type of faults for Huawei converged storage, and has no special requirement for maintenance personnel.

TRUE

FALSE

The *HCIP-Storage V5.5 Training Material (Module 5: Storage System Maintenance and Troubleshooting)* discusses fault rectification: “The replacement method, which involves swapping components to identify faults, is effective for hardware issues but not suitable for all fault types (e.g., software or configuration errors). It requires trained maintenance personnel with knowledge of system architecture and safety procedures to avoid service disruptions.” The statement that it can address any fault type and has no special personnel requirements is false, as the method is limited and demands expertise.
Reference:
HCIP-Storage V5.5 Training Material, Module 5: Storage System Maintenance and Troubleshooting, Section 5.27: Fault Rectification Methods*, Huawei Technologies Co., Ltd.

QUESTION 53
When the HyperReplication feature of Huawei scale-out storage is applied, If the properties of a consistency group are modified, the property modification will be synchronized to each pair in the consistency group. That is, the properties of the consistency group prevail.

TRUE

FALSE

QUESTION 54
In Huawei flash storage, NFS shares support lightweight directory access protocol (LDAP) authentication, network information service (NIS) authentication, and local user authentication.

TRUE

FALSE

Huawei flash storage NFS shares support multiple user authentication methods, including LDAP, NIS, and local user authentication, to meet different access control and integration requirements.

QUESTION 55
A government customer has purchased several Huawei scale-out storage devices, and an engineer wants to install the distributed parallel client (DPC). When creating DPC nodes, the engineer can manually add a node by entering the service IP address of the node.

TRUE

FALSE

The Distributed Parallel Client (DPC) in Huawei OceanStor Pacific systems enables parallel file access. The *HCIP-Storage V5.5 Training Material (Module 3: Scale-Out Storage Technologies)* explains: “When adding DPC nodes, engineers can manually add nodes using DeviceManager by entering the management IP address of the node, not the service IP address. The management IP is used to establish control plane communication for node integration.” The service IP address is used for data access by clients, not for node creation or management tasks. Therefore, the statement that the engineer can add a node using the service IP address is false.
Reference:
HCIP-Storage V5.5 Training Material, Module 3: Scale-Out Storage Technologies, Section 3.7: DPC Installation and Node Management*, Huawei Technologies Co., Ltd.
—

QUESTION 56
To prevent misoperations from affecting services, a storage system controls user operation permissions and scopes based on user levels and roles. Which of the following is not a tenant management user role in the storage system?

Tenant administrator

Tenant protocol administrator

Tenant data protection administrator

Security administrator

The *HCIP-Storage V5.5 Training Material (Module 5: Storage System Maintenance and Troubleshooting)* lists tenant management roles: “Tenant management roles include tenant administrator, tenant protocol administrator, and tenant data protection administrator, which manage resources, protocols, and data protection tasks within a tenant’s scope.” The security administrator is a system-wide role, not specific to tenant management, as it handles global security policies. Thus, option D is not a tenant management role.
Reference:
HCIP-Storage V5.5 Training Material, Module 5: Storage System Maintenance and Troubleshooting, Section 5.25: Tenant Role Management*, Huawei Technologies Co., Ltd.
—

QUESTION 57
The following description does not belong to the features of 0ceanStor9000:

Self-developed distributed file system OceanStor DFS supports massive unstructured data storage and realizes a global unified namespace.

Provide object storage services, compatible with Amazon S3 interface and compatible with OpenStack Swift interface.

Support for docking Fusionlnsight Hadoop/Cloudera Hadoop packaged by open source Hadoop components, allowing users Easily build an enterprise-level big data analysis platform.

Distributed metadata management, supporting linear expansion of 3~4000 nodes exhibition.

Loading …