Get Started NACE-CIP1-001 Exam [year] Dumps NACE PDF Questions [Q57-Q80]

Q57. Which is a component that supplies most of the features and functions of the material?

Q58. Due to a previous premature coating failure the owner has required the original coating applicator to return to remove and replace 10,000 square feet of a failed three coat system at the applicator’s cost. Due to the financial implications of another failure, the owner has offered you the job as the NACE CIP Level 1 Coating Inspector and explained that he expects you to be his “insurance policy” for this job. You have never been involved in a warranty job before and are unfamiliar with the coating system.
Your preferred FIRST course of action is to:

Q59. Dew point is the temperature at which

Q60. Common errors that may produce inaccurate readings when using a Dial-Type Magnetic Pull-Off Dry Filth Thickness (DFT) gauge include:
Select All That Apply

Q61. Which of these tests uses a syringe?

Q62. The main responsibilities of the inspector are to

Q63. As a NACE Coating Inspector your responsibility with respect to safety is to:

Q64. In the event of a conflict between the project specification and the coating manufactures’ product data sheet, the Inspector’s first course of action should be too:

Q65. A NACE Coating Inspector is permitted to transport coating material when:

Q66. Inspection documentation is important because:

Q67. Stripe coats are generally applied to:

Q68. If a Thermoset coating is heated it will:

Q69. What is the minimum spot measurement value allowed by SSPC-PA 2 in each 10 m2 (100 ft2) area?

Q70. Which one of these elements is not necessary for corrosion to occur:

Q71. Digital hygrometers

Q72. If inspectors identify issues of non-conformance during an inspection, they should

Q73. Removal of surface contaminants is done by:

Q74. The least effective method of surface cleaning is most likely

Q75. Fine cracks in the surface of a coating that rarely reach the substrate are called

Q76. Conventional spray is a good choice when:

Q77. If the specifier does not identify a restriction level in accordance with SSPC PA 2, the default restriction level is:

Q78. In a non-convertible coating the role of the primary solvent is to:

Q79. Check abrasive blast pressure with a

Q80. You are the NACE Inspector on a job where the Owner’s specification requites you to perform a twice daily check of blast pressure at the nozzle. It is now day 30 on the job and all of your readings have been within compliance. The Contractor complains that these checks taking up much time and in view of the compliant results they are unnecessary.
Your FIRST preferred course of action is to: