[Aug-2023] OSP-002 Dumps Full Questions – OSP Certification Exam Study Guide [Q75-Q96]

NO.75 The difference between the termination schemes of T568A and T568B is ______?

NO.76 Copper networks can be converted to fiber optics using __________.

NO.77 Before UTP cabling became widely used and the industry standard, most Ethernet Networks were connected over _______ cable.

NO.78 What is the maximum length of a permanently installed UTP cabling link allowed in structured cabling standards?

NO.79 The principle of operation of OTDRs is similar to _______.

NO.80 Potential sources of interference for wireless LANs include _______.

NO.81 Premises cables must be rated for __________ to meet codes.

NO.82 Coarse wavelength division multiplexing (CWDM) systems require __________ to allow transmitting in the E-Band (1260-1360 nm).

NO.83 For testing a terminated fiber optic cable or a patchcord, the instrument(s) you need is (are):

NO.84 In singlemode connectors, __________ is as important as low loss.

NO.85 Which fiber typically has the largest core?

NO.86 Underground cable generally includes a gel, powder or tape for protection from __________.

NO.87 The total loss of the fiber in the cable plant is calculated by multiplying the attenuation coefficient of the fiber by the _________.

NO.88 The diameter of the core in OM2 and OM3 multimode fiber is how large?

NO.89 The largest contributor to fiber attenuation is __________.

NO.90 Wireless networks require cables to connect the server, router or hub to the ______.

NO.91 What cable types are included in the TIA-568 structured cabling standards?

NO.92 To maintain rated performance, twists in each pair must be maintained to within _______ of the termination.

NO.93 Concatenation or the joining of two cables in a long outside plant run is almost always done by
__________.

NO.94 Gigabit Ethernet uses all four pairs of a UTP cable _________.

NO.95 What UTP installation tool is needed for teminating most Cat 5e/6 jacks?

NO.96 What is the cabling from the telecom closet to the main cross connect or computer center called?